- Fix for initialization-time failure if the kernel was built without CONFIG_SWAP. Without the patch, it would fail during initialization with the error: "crash: cannot resolve: nr_swapfiles" (anderson(a)redhat.com) - Fix for the "bt" command when run on x86_64 kernels that contain the x86/x86_64 merger patch. Without the patch, non-active (blocked) tasks do not start with "schedule", and as a result may contain stale frame entries. (anderson(a)redhat.com) - Fix for the usage of an input file of commands redirected during runtime via "<", where more than one command in the input file results in a fatal error. Without the patch, the handling of the input file would go into an infinite loop repeatedly running the second failed command. (anderson(a)redhat.com) - Clean up causes for warning messages when compiling with gcc 4.3.2. (anderson(a)redhat.com) - Fix to prevent a segmentation violation during initialization when parsing (corrupted) module symbols. Without the patch, if a kernel module's Elf32_Sym/Elf64_Sym data structure contains a corrupt "st_index" field, the resultant string table access could cause a segmentation violation. (anderson(a)redhat.com) - If an active task experiences a kernel stack overflow, the task's thread_info structure located at the very bottom of the stack will likely have its "cpu" field corrupted. Without the patch, any task with a corrupt cpu value is not accepted, and the error message "crash: invalid task: <task-address>" is displayed. With the patch, an active task will be accepted based upon its existence as the current task in a per-cpu runqueue structure, and there will be a warning message indicating that the cpu value is corrupt. (anderson(a)redhat.com) - Modification of the the "files" command when a task has an open file referenced by a file descriptor, but the file structure's f_dentry field is NULL. This is a kernel error condition, but without this patch the "files" command does not display anything for that file descriptor, as if the file has been closed or is not in use. This patch displays the file descriptor number and the file structure's virtual address. (anderson(a)redhat.com) - Fix for the "bt" command on x86 Xen architectures when the backtrace starts on the hard IRQ stack. Without the patch, the backtrace may not properly make the transition back to the process stack with the error message "bt: invalid stack address for this task", or it may cause a segmentation violation. (anderson(a)redhat.com) Download from: http://people.redhat.com/anderson