I've run into a problem with the ATA SCSI disk driver when running in a kdump dump-capture kernel. I'm running on 2-processor x86_64 box. It has 2 scsi disks, /dev/sda and /dev/sdb My kernel is 2.6.22, and built to be a dump capturing kernel loaded by kexec. When I boot this kernel by itself, it finds both sda and sdb. But when it is loaded by kexec and booted on a panic it only finds sda. Any ideas from those familiar with the ATA driver? -Cliff Wickman SGI I put some printk's into it and get this: Standalone: [nv_adma_error_handler] cpw: ata_host_register probe port 1 (error_handler:ffffffff81348625) cpw: ata_host_register call ata_port_probe cpw: ata_host_register call ata_port_schedule cpw: ata_host_register call ata_port_wait_eh cpw: ata_port_wait_eh entered cpw: ata_port_wait_eh, preparing to wait ata2: SATA link up 1.5 Gbps (SStatus 113 SControl 300) cpw: ata_dev_configure entered cpw: ata_dev_configure testing class cpw: ata_dev_configure class is ATA_DEV_ATA ata2.00: ATA-6: ST3200822AS, 3.01, max UDMA/133 ata2.00: 390721968 sectors, multi 16: LBA48 cpw: ata_dev_configure exiting cpw: ata_dev_configure entered cpw: ata_dev_configure testing class cpw: ata_dev_configure class is ATA_DEV_ATA cpw: ata_dev_configure exiting cpw: ata_dev_set_mode printing: ata2.00: configured for UDMA/133 cpw: ata_port_wait_eh, finished wait cpw: ata_port_wait_eh exiting cpw: ata_host_register done with probe port 1 When loaded with kexec and booted on a panic: cpw: ata_host_register probe port 1 (error_handler:ffffffff81348625) cpw: ata_host_register call ata_port_probe cpw: ata_host_register call ata_port_schedule cpw: ata_host_register call ata_port_wait_eh cpw: ata_port_wait_eh entered cpw: ata_port_wait_eh, preparing to wait ata2: SATA link up 1.5 Gbps (SStatus 113 SControl 300) cpw: ata_port_wait_eh, finished wait cpw: ata_port_wait_eh exiting cpw: ata_host_register done with probe port 1